We used Port 3, Pin 17 for the Laser PWM signal and Pin 25 for the Ground Signal. We used Port 3 as our outputs from the breakout board to control the laser. J Tech Laser – If you have a mach4 machine, then try the Generic Bundle here:.We used the generic screw terminal board to get access to the signals.

Breakout Board for the Smooth Stepper – There are a lot of options for this.

Our instructions for the laser will only work with this board.

Ethernet Smooth Stepper Control Board – This is the control board you need to run Mach4.

So, we have answered the call and have set up Mach4 on our lab machine and want to share how to get it done for everyone.

We have been getting requests to make a page on how to set up Mach4 for J Tech Lasers, as it is a bit confusing on the website on how to get the laser set up. Makerbot Replicator 2 and 2x Laser Upgradeīy jtechphotonicscom on Apin Setup Instructions Our Advice When Setting Up Mach4 with ESS and J Tech Lasers.Generic Magnet Mounting Bundle Instructions.Vectric Non-Laser Module Post Processors.Advanced optoelectronics for Industry, Research, and Enthusiasts.

Lightburn images are not aligned